Skip to main content
Skip table of contents

Block a Thread

Sometimes it may be necessary to delay the execution of an xUML service. To block the current activity for a given period of time, you can use the Block Thread Adapter.

Figure: Block Thread Action

Each blocked thread consumes a Bridge license slot. Each blocked thread that contains persistent states also blocks a persistent state worker. For more information on E2E Bridge licensing, refer to License for Running xUML Services and Performance Considerations of Persistent State.

You can use the Action Wizard to add a <<BlockThread>> action. Add an empty action node and select E2E Action Wizard from the context menu.

Specify the name of the action and select stereotype BlockThread from the list of stereotypes.

Add the necessary parameter to specify the period of time to wait:

  • Select time to specify a period of time in seconds.
  • Select highResolutionTime to specify a period of time in milliseconds.
Click Finish.

Parameters

NameTypeDirectionMandatoryDescriptionAllowed Values
timeIntegerin(tick)Specify a period of time in seconds defining the sleep time.any integer
highResolutionTimeIntegerin(tick)Specify a period of time in milliseconds defining the sleep time.any integer

Specify either time or highResolutionTime or both. If you do not specify any of the two, an exception "Sleep time is missing" will be thrown during execution of the service.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.