Skip to main content
Skip table of contents

Test Case Properties - Lesson 3

Click the test case queryProducts:

In the right panel of the Analyzer window an additional tab UML appears, saying "This test case has not been run yet with trace enabled". This is correct as this test case has been created with the E2E SOAP Test Tool which does not support tracing.

Select Properties from the test case's context menu:

Switch to the Trace tab, enable trace and check the option Full Trace. Click OK:

Run the test case again to collect the trace information:


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.