The BUILDER can be updated via the Resource Manager of MagicDraw. You can install BUILDER updates in two different ways:
When updating the BUILDER, please consider the necessary installation rights.
You can download official patches directly from the MagicDraw Resource Manager.
To do this, proceed as follows:
Open the Resource/Plugin Manager.
Look for the Cameo E2E Builder plugin. It is listed under Plugins (no cost). If no new version is listed, you can trigger an update check by clicking Check for Updates at the top of the list. | ||
MagicDraw downloads the new BUILDER version. | ||
Click OK and restart MagicDraw to enable the new BUILDER version. |
There may be cases you do not want to wait for an official patch to be released, but you want to install a BUILDER patch manually that was provided to you via our software FTP.
To do this, proceed as follows:
Open the Resource/Plugin Manager.
Click Import to choose the BUILDER Plugin ZIP-File. | |
Select the ZIP-file of the version you want to install and click Open. | |
The BUILDER gets extracted. | |
TheĀ BUILDER has been installed successfully and will be available after restarting MagicDraw. Click OK. | |
The MagicDraw Resource/Plugin Manager shows that the BUILDER has been installed. Click Close. |
Restart MagicDraw to make the BUILDER plugin available.
If you did not follow the hint on the top of this page, you must provide administration rights on the first restart after an update.
After having updated your BUILDER installation, you might want to have a look at Starting the Builder After an Update.