In cases the target and the source type do not match, or you want to perform some other transformation with the mapping, you can add operations to mapping relations.
| Drag out the needed operation from the service panel to the mapping operation area - the grey section in the middle of the mapping editor. You can do this with any operation: Operations from your data model or the Base Types, as well as operations from imported libraries or connectors. |
| Once you have added the operation to the mapping diagram, you can connect the source and target properties to the operation pins. |
| If you want to create a new mapping operation, you can click the mapping operation icon and drag it to the grey mapping operation area. |
| The new operation is now displayed in the mapping diagram. When you create a new operation by dragging it from the elements toolbar, it inherits the Static attribute of the mapping diagram it is dragged to. If the option Show invalid is enabled in the mapping toolbar, the operation will be highlighted in red until at least one output parameter is created for it. You can create parameters directly in the Mapping Editor using the two icons that appear above the operation when you hover over it. |
Overview
Content Tools