Page History

Then, open a Web browser and enter the URL of the Bridge in the address bar. If you use a proxy, make sure that the proxy is bypassed for localhost, or alternatively for the external name or IP address of the node instance, where the Bridge BRIDGE has been installed.
If the Bridge BRIDGE runs on your local system, you can enter the URL for a local connection (https://localhost:8080). Note that the port 8080 was suggested as default value during the Bridge BRIDGE installation. If you changed that value, you have to enter the new port number in the URL. Note, that the URL is case sensitive.

During the installation, a self-signed certificate was created and will be used to encrypt the communication between members of an E2E Bridge a BRIDGE domain and when deploying xUML services from MagicDraw (E2E BuilderScheer PAS BUILDER).
When entering the URL of the BridgeBRIDGE, the Web browser will display a security alert, as the Bridge BRIDGE runs with this self-signed security certificate, whose name may not match to the name of the site, or the certifying authority is not known by the browser. As this is a default certificate, always accept this certificate to run the BridgeBRIDGE.

If you have any problems accessing the page, try the following:

• Make sure that you bypass the proxy server for localhost with your browser.
• Disable all caches, proxies, etc. (e.g. by selecting direct connection to the internet in the browser settings).
• Instead of localhost, use the external name or IP address of the server (e.g. https://education.e2e.ch:8080).
• Port 8080 is the default port. If you changed it during the installation, make sure to use the correct port number in the URL.
• Check if the Windows service/Unix daemon of the Bridge BRIDGE is running.